How to turn on the red light of laser marking machine?
想必許多操作過激光打標機的用戶都對打標機紅光
水泥桿 保定空壓機 保定古箏 塑料增韌劑 拱形護坡模具 保定空調維修 托輥設備 托輥生產線
指示系統有一定的見解。一臺激光打標機的出產必定會包含紅光指示系統在內，在此也常常被大家稱為紅光調節。然而紅光調節的功能有很多，也對激光打標機標識定位起到至關重要的作用。Presumably, many users who have operated the laser marker have some opinions on the red light indicator system of the marker. The production of a laser marking machine must include a red light indicator system, which is often called red light regulation. However, there are many functions of red light regulation, and it also plays a vital role in the identification and positioning of laser marking machine.
紅光調節的作用主要包含以下三點：
The role of red light regulation mainly includes the following three points:
1、紅光調節作為指示光，在調節諧振腔光路上使用；
1. Red light regulation is used as indicator light on the optical path of the adjusting resonator.
2、紅光還可作為激光打標機的聚焦點，也就是打標距離的指示；
2. Red light can also be used as the focus of laser marking machine, which is the indication of marking distance.
3、作為激光打標機打標定位用的指示光，根據打標軟件的不同，可以分為打標中心點指示、打標圖案的長寬范圍指示，打標圖案的整體模擬指示等多種指示方法；
3. As an indicator light for marking and positioning of laser marking machine, according to the different marking software, it can be divided into marking center point indication, marking pattern length and width indication, marking pattern overall simulation indication and other indicators.
需要特別注意的是要開啟激光打標機紅光調節，則需要操作人員對設備有一定的了解才行，比如，一般的激光打標機廠商的紅光調節開啟都是在打標軟件上的。紅光開關按鍵盤F1即可開、關或在打標界面上開啟紅光按紐進行操作，如果你只發現振鏡在運動而沒有紅光出來，那么先查看一下，控制紅光是不是有機械開關沒有開啟，看一下紅光的電源有沒有打開，使用萬用表測量一下，紅光指示器的二條紅黑色之間有沒有5V電壓，如果是5V電壓而沒有激光輸出，那么可以肯定的是紅光指示器需要更換了。
Special attention should be paid to turning on the red light adjustment of laser marking machine. Operators need to have a certain understanding of the equipment. For example, the red light adjustment opening of general laser marking machine manufacturers is on the marking software. The red light switch keypad F1 can be turned on, off or on the marking interface to open the red light button for operation. If you only find that the galvanometer is moving without the red light coming out, check first to see if there is a mechanical switch to control the red light. See if the red light power is turned on. Use a multimeter to measure whether there is 5V electricity between the two red and black lights of the red light indicator. Voltage, if it is 5V voltage without laser output, then it is certain that the red light indicator needs to be replaced.